Enhancing the growth of Vicia faba plants by microbial inoculation to improve their phytoremediation potential for oily desert areas

Two experiments were conducted to investigate the effect of inoculating Vicia faba plants (broad beens) raised in clean and oily sand with nodule-forming rhizobia and plant-growth-promoting rhizobacteria (PGPR) on growth of these plants in sand and to test whether this can improve the phytoremediation potential of this crop for oily desert areas. It was found that crude oil in sand at concentrations < 1.0% (w/w) enhanced the plant heights, their fresh and dry weights, the total nodule weights per plant, and the nitrogen contents of shoots and fruits. Similar enhancing effects were recorded when roots of the young plants were inoculated with nodule bacteria alone, PGPR alone, or a mixture of one strain of nodule bacteria and one of the PGPR. Such plant growth effects were associated with a better phytoremediation potential of V. faba plants for oily sand. The total numbers of oil-utilizing bacteria increased in the rhizosphere and more hydrocarbons were eliminated in sand close to the roots. The nodule bacteria tested were two strains of Rhizobium leguminosarum and the PGPR were Pseudomonas aeruginosa and Serratia liquefaciens. The four strains were found to use crude oil, n-octadecane, and phenanthrene as sole sources of carbon and energy. It was concluded that coinoculation of V. faba plant roots in oily sand with nodule bacteria and PGPR enhances the phytoremediation potential of this plant for oily desert sand through improving plant growth and nitrogen fixation.     

On-line monitoring of CO2 production in Lactococcus lactis during physiological pH decrease using membrane inlet mass spectrometry with dynamic pH calibration

Monitoring CO2 production in systems, where pH is changing with time is hampered by the chemical behavior and pH-dependent volatility of this compound. In this article, we present the first method where the concentration and production rate of dissolved CO2 can be monitored directly, continuously, and quantitatively under conditions where pH changes rapidly ( approximately 2 units in 15 min). The method corrects membrane inlet mass spectrometry (MIMS) measurements of CO2 for pH dependency using on-line pH analysis and an experimentally established calibration model. It is valid within the pH range of 3.5 to 7, despite pH-dependent calibration constants that vary in a non-linear fashion with more than a factor of 3 in this interval. The method made it possible to determine the carbon dioxide production during Lactococcus lactis fermentations, where pH drops up to 3 units during the fermentation. The accuracy was approximately 5%. We used the method to investigate the effect of initial extracellular pH on carbon dioxide production during anarobic glucose fermentation by non-growing Lactocoocus lactis and demonstrated that the carbon dioxide production rate increases considerably, when the initial pH was increased from 6 to 6.8.     

Structure of the O-specific polysaccharide from Shewanella japonica type strain KMM 3299T containing the rare amino sugar Fuc4NAc

An acidic O-specific polysaccharide (PS) of the agar-digesting bacterium Shewanella japonica with the type strain KMM 3299(T) was obtained by mild acid hydrolysis of the lipopolysaccharide. The polysaccharide was studied by component analysis, methylation analysis, (1)H and (13)C NMR spectroscopy, including 2D NMR experiments. The PS was determined to have the following structure involving three unusual amino sugars:     

Structure of an acidic polysaccharide from the marine bacterium Pseudoalteromonas aliena type strain KMM 3562T containing two residues of L-serine in the repeating unit

The structure of an acidic polysaccharide from Pseudoalteromonas aliena type strain KMM 3562(T) has been elucidated. The polysaccharide was studied by component analysis, (1)H and (13)C NMR spectroscopy, including 2D NMR experiments. A (1)H, (13)C band-selective constant-time heteronuclear multiple-bond connectivity experiment was used to determine amide linkages, between serine and uronic acid (UA) residues, via (3)J(H,C) correlations between Ser-alphaH and UA-C-6. It was found that the polysaccharide consists of pentasaccharide repeating units with the following structure: [carbohydrate structure]; see text.     

The O-chain structure from the LPS of marine halophilic bacterium Pseudoalteromonas carrageenovora-type strain IAM 12662T

The O-chain polysaccharide of the lipopolysaccharide from the halophilic marine bacterium Pseudoalteromonas carrageenovora IAM 12662T was characterized. The structure was studied by means of chemical analysis and 2D NMR spectroscopy of the de-O-acylated lipopolysaccharide and shown to be the following:Col is colitose, 3,6-di-deoxy-L-xylo-hexose.     

Structural characterisation of a highly branched exopolysaccharide produced by Lactobacillus delbrueckii subsp. bulgaricus NCFB2074

Lactobacillus delbrueckii subsp. bulgaricus NCFB2074 when grown in skimmed milk secretes a highly branched exopolysaccharide. The exopolysaccharide has a heptasaccharide repeat unit and is composed of glucose and galactose in the molar ratio 3:4. Using chemical techniques and 1D and 2D NMR spectroscopy the polysaccharide has been shown to possess the following repeat unit structure: [carbohydrate structure: see text].     

The puhE gene of Rhodobacter capsulatus is needed for optimal transition from aerobic to photosynthetic growth and encodes a putative negative modulator of bacteriochlorophyll production

A conserved orf of previously unknown function (herein designated as puhE) is located 3' of the reaction centre H (puhA) gene in purple photosynthetic bacteria, in the order puhABCE in Rhodobacter capsulatus. Disruptions of R. capsulatus puhE resulted in a long lag in the growth of photosynthetic cultures inoculated with cells grown under high aeration, and increased the level of the peripheral antenna, light-harvesting complex 2 (LH2). The amount of the photosynthetic reaction centre (RC) and its core antenna, light-harvesting complex 1 (LH1), was reduced; however, there was no decrease in expression of a lacZ reporter fused to the puf (RC and LH1) promoter, in RC assembly in the absence of LH1, or in LH1 assembly in the absence of the RC. In strains that lack LH2, disruption of puhE increased the in vivo absorption at 780 nm, which we attribute to excess bacteriochlorophyll a (BChl) pigment production. This effect was seen in the presence and absence of PufQ, a protein that stimulates BChl biosynthesis. Expression of puhE from a plasmid reduced A(780) production in puhE mutants. We suggest that PuhE modulates BChl biosynthesis independently of PufQ, and that the presence of excess BChl in PuhE(-)LH2(+) strains results in excess LH2 assembly and also interferes with the adaptation of cells during the transition from aerobic respiratory to anaerobic photosynthetic growth.     

Performance of a substratum-irradiated photosynthetic biofilm reactor for the removal of sulfide from wastewater

The performance of a sulfide-removal system based on biofilms dominated by green sulfur bacteria (GSB) has been investigated. The system was supplied with radiant energy in the band 720-780 nm, and fed with a synthetic wastewater. The areal net sulfide removal rate and the efficacy of the incident radiant energy for sulfide removal have been characterized over ranges of bulk sulfide concentration (1.6-11.5 mg L(-1)) and incident irradiance (0.21-1.51 W m(-2)). The areal net sulfide removal rate increased monotonically with both increasing incident irradiance and increasing bulk sulfide concentration. The efficacy of the radiant energy for sulfide removal (the amount of sulfide removed per unit energy supplied) also increased monotonically with rising bulk sulfide concentration, but exhibited a maximum value with respect to incident irradiance. The maximum observed values of this net removal rate and this efficacy were, respectively, 2.08 g m(-2) d(-1) and 2.04 g W(-1) d(-1). In-band changes in the spectral composition of the radiant energy affected this efficacy only slightly. The products of sulfide removal were sulfate and elemental-S. The elemental-S was scarcely released into the liquid, however, and reasons for this, such as sulfur reduction and polysulfide formation, are considered. Between 1.45 and 3.85 photons were needed for the net removal of one electron from S-species. Intact samples of the biofilm were characterized by microscopy, and their thicknesses lay between 39 +/- 9 and 429 +/- 57 microm. The use of the experimentally determined rates and efficacies for the design of a pilot-scale system is illustrated.     

New drying process for lactic bacteria based on their dehydration behavior in liquid medium

This study describes the different stages of optimization in an original drying process for lactic acid bacteria that allows the retrieval of dried samples of Lactobacillus plantarum with maximum viability. The process involves the addition of casein powder to bacterial pellets, followed by mixing and then air-drying in a fluidized bed dryer. The effects on bacterial viability of the a(w) of the casein powder and the kinetics of a(w) variation in the fluidized bed dryer are considered. These parameters were first studied in a water-glycerol solution and the results were then applied to the drying process. Data from the study in liquid medium were reliable in the fluidized drying stage, insofar as optimal viability was achieved for similar dehydration times (16-50 min in liquid medium, and 30 min in the fluidized bed dryer). However, when the powder was mixed rapidly with bacteria, the level of destruction differed from that observed in liquid medium. Viability was up to 70% when the a(w) of water-glycerol was 0.55, whereas it was only 2.1% when the a(w) of the casein-bacterial mix was 0.64. The predictive capacity of dehydration in liquid medium is discussed with regard to the permeability of cells to external solutes. The new process allowed 100% survival of L. plantarum after complete drying (final a(w) < 0.2). However, when used for the desiccation of L. bulgaricus, these parameters achieved a viability of less than 10%.     

In vitro laser ablation of laboratory developed biofilms using an Nd:YAG laser of 532 nm wavelength

We studied the laser ablation of laboratory-developed biofilm on titanium and glass surfaces. Specifically, Pseudoalteromonas carrageenovora, a marine biofilm forming bacterium was used to generate laboratory biofilm. Two fluences, 0.05 and 0.1 J/cm(2) and three durations of irradiation, 30 s, 5 min, and 10 min were tested using an Nd;YAG laser of 532 nm wavelength (in the green light area). Nonirradiated coupons with biofilm served as control. The biofilm removal efficiency increased with the increase in laser fluence and duration of irradiation. The maximum biofilm area cover on control coupons of glass and titanium was 62.5 and 76.0%, respectively. Upon irradiation with fluence 0.1 J/cm(2) for the very short duration of 30 s, this reduced to 5.6 and 12.4% and at 10 min to 2.17 and 0.7% on glass and titanium coupons, respectively, while the controls did not show any reductions (62.5 and 76.0% respectively, for glass and titanium coupons). The biofilm TRC (Total Resuscitated Cells) reduction during this period was even more prominent than the area cover, indicating that the remaining biofilm portions on coupons after irradiation were largely composed of dead bacterial cells. The TRC in the irradiation chamber medium for short durations of irradiation showed a significant increase, indicating that the laser irradiation removed live bacteria from the biofilm. The re-growth of the resuscitated cells showed they could grow like the control cells but with a significant lag. The laser's efficiency in the removal of biofilm was better seen on titanium coupons than on glass. Our results showed that a low-power pulsed laser irradiation could be used to remove biofilm formed on hard surfaces.